No vendas mi información personal.

Como se describe en nuestra Política de Privacidad, recopilamos información personal de sus interacciones con nosotros y nuestro sitio web, incluso a través de cookies y tecnologías similares. También podemos compartir esta información personal con terceros, incluidos socios publicitarios. Hacemos esto para mostrarle anuncios en otros sitios web que sean más relevantes. a sus intereses y por otros motivos descritos en nuestra política de privacidad.

Compartir información personal para publicidad dirigida en función de su interacción en diferentes sitios web puede considerarse "ventas", "compartir" o "publicidad dirigida". bajo ciertas leyes de privacidad estatales de EE. UU. Dependiendo de dónde viva, es posible que tenga derecho a optar por no participar en estas actividades. Si desea ejercer este derecho de exclusión voluntaria, Por favor, siga las siguientes instrucciones.

Si visita nuestro sitio web con la señal de preferencia de exclusión voluntaria del Control de privacidad global habilitada, dependiendo de dónde se encuentre, lo trataremos como una solicitud para cancelar la actividad. que puede considerarse una "venta" o "compartir" información personal u otros usos que pueden considerarse publicidad dirigida para el dispositivo y el navegador que utilizó para visitar nuestro sitio web.

93%

(880)

(47)

(15)

(4)

(5)

702

Great product and packaging couldn't be happier

Great product fast delivery. I couldn't be happier

It's a sticker!

The sticker, what can you say? I love my stickers, if only to represent my favorite companies. You have to do good, be good and Thor's Lightning is all of that and more.

Great air chuck

I've had these a few months now, and I have used them about 10-12 times. They are awesome, fast and easy to use with a good leak free seal. I would definitely recommend them over the other ones i have used.

Refuge for 2010+ 4runner Bracket is a perfect fit!

The bracket is well designed. None of the hardware included was correct, but just $5 at Ace corrected the issue. I used 1/4x20 carriage bolts with nylok nuts to attaches the compressor to the plate. For the two front studs near the air box I used two flange lok nuts and thick washers. With the compressor mounted to the plate, I set the assembly down into the location. A factory harness and plug that is attached to the fender has to be popped free from the hole that located it and moved down in order to clear the compressor head. Start the washer and nut on the front stud nearest the fender making sure the ground cable that routes under is not pinched. Then start the other washer and nut on the other front stud. Once those are loosely threaded on, use the factory washer nut combo for the stud nearest the firewall. This can be reached easier if the cowell panel is popped loose a bit. Thread the nut on as far as possible by hand then use a 12mm wrench to tighten. This nut is installed completely blind, but is possible. Finally, fully tighten the two front nuts and you're done! I ran an air chuck up front located in the same hole cut to access my winch clutch. I also left the compressor cable clamps in tact so as to not affect my warranty.